CNC Pro Chucker 7 Die Plate (SKU: T1595)This Die Plate for the RCBS Pro Chucker 7 reloading press is CNC Machined to precise tolerances from 6061-T6 aluminum. The die stations are threaded to a Class 2B fit. The die plate is solid, over 1" thick and flat on the bottom ... making it much stronger with less flex than a cast die plate.
||Component Recovery Cup (SKU: T1668)Component Recovery Cup™ separates powder from bullet and case when pulling bullets. Powder drains directly back into powder measure hopper for immediate reuse.||Foam Grip (SKU: T1527)This foam grip cushions your hand yet provides good "feel" when seating primers. Fits both the Plastic and Aluminum Dillon Roller Handles … as well as most other press handles that are approximately 1" diameter and 4" to 5" long.||Light-Load II Shellplate Illuminator (SKU: T1731)Battery-powered LED light illuminates your Dillon RL 550B, XL 650 or XL 750 shellplate. Also fits Hornady Lock-N-Load AP™ press. Can also be used on any progressive press with a vacant die mounting hole.||Primer Tube Stand (SKU: T1567)The UniqueTek Primer Tube Stand holds up to 12 primer pickup tubes, 6 on each side, in a horizontal position. The Stand has a base that is wide enough to be stable and not easily tipped over. It assembles in just seconds and can easily be dismantled to save bench space when not in use.||RCBS Die Wrench (SKU: T1560)The best and last die wrench you'll ever need for 1-3/16″ RCBS die lock rings. Box ends for maximum strength. Thin walled to easily fit between closely spaced dies. Double-ended to fit both 1-3/16″ and 1-1/8″ Die Lock Rings.|
|The Bin-Dam (SKU: T1359)The Bin-Dam™ fits into the front of the Cartridge Collection Bin for Dillon, LEE and RCBS reloading presses. It keeps rounds from rolling out and onto the floor when the bin gets near full. Allows use of 100% of bin's capacity. Available in three sizes to fit the cartridge collection bins for SDB/550/650 presses, the 1050 press, and for the SL 900 Shotshell Loader.|