| Items: | 0 |
| Subtotal: | $0.00 |
Enhancements for Other Reloading Presses
 .45 HTC Powder Through Expander (SKU: T1729-04)This Powder Through Expander (PTX™) was specially designed for loading .45 caliber cast/coated bullets sized to 0.451″ to 0.452″ OD, that would provide for minimum swaging of the bullet’s base and preventing shaving polymer bullet coatings (e.g. Hi-Tek).
|
 Bulk Powder Feed Kit (SKU: T1676)The Bulk Powder Feed™ Kit continuously refills your powder measure, keeping your powder hopper at a constant full level. It gravity feeds gunpowder directly from an 8lb or 4lb container. |
 Foam Grip (SKU: T1527)This foam grip cushions your hand yet provides good "feel" when seating primers. Fits both the Plastic and Aluminum Dillon Roller Handles … as well as most other press handles that are approximately 1" diameter and 4" to 5" long. Sold in a 2-Pack.
|
 Loaded Round Counter (SKU: T1555)The UniqueTek Loaded Round Counter is an electronic counter for your Dillon press that counts only successfully loaded rounds ... not just press cycles. Can also be used on many other reloading presses that have: 1) Have a Crimp Die with an open top, and 2) Have a primer magazine tube or similar place on which to mount the LCD Display Module.
|
 Powder Through Expanders (SKU: T1729)If you use the Mr. Bulletfeeder on a Hornady Lock-N-Load® AP™ press, you'll want one of these redesigned Powder Through Expanders (PTX™). The dimensions of the expander tip have been optimized for use with the Mr. Bullerfeeder bullet dropper. Some guys find it works better than the original Hornady PTX™ … even without a Mr. Bulletfeeder.
|
 Primer Tube Stand (SKU: T1567)The UniqueTek Primer Tube Stand holds up to 12 primer pickup tubes, 6 on each side, in a horizontal position. The Stand has a base that is wide enough to be stable and not easily tipped over. It assembles in just seconds and can easily be dismantled to save bench space when not in use.
|
 RCBS Die Wrench (SKU: T1560)The best and last die wrench you'll ever need for 1-3/16″ RCBS die lock rings. Box ends for maximum strength. Thin walled to easily fit between closely spaced dies. Double-ended to fit both 1-3/16″ and 1-1/8″ Die Lock Rings.
|
 The Bin-Dam (SKU: T1359)The Bin-Dam™ fits into the front of the Cartridge Collection Bin for Dillon, LEE and RCBS reloading presses. It keeps rounds from rolling out and onto the floor when the bin gets near full. Allows use of 100% of bin's capacity. Available in three sizes to fit the cartridge collection bins for SDB/550/650 presses, the 1050 press, and for the SL 900 Shotshell Loader.
|
 Toolhead Clamp Kit (SKU: T1230)The UniqueTek Toolhead Clamp Kit™ enables your Dillon 550, 650 and 750 toolheads, and RCBS Pro 2000®/Piggyback™ -3 & -4 dieplates, to be CLAMPED into the press frame. This corrects the loose fit between the toolhead and press frame, thus reducing OAL variation and improving die-to-shellplate alignment.
|