|Click to enlarge image(s)|
• Large 3" x 10" Magnetic Surface
• Holds Most Metal Magazines
• Holds Up To 3 Pounds (total)
• Attaches To Any Surface, Not Just Metal
• Install on Interior of Exterior of Gun Safe
Mounts on Any Surface
Metal: Peel off the protective paper to expose the adhesive, then just press onto desired location.
Drywall: Peel off the protective paper to expose the adhesive, then press onto desired location. Drive 3/4" nails (included) into pre-drilled holed on four corners.
Wood: Use the tacks (included) in the six pre-drilled holes.*
* Thickly carpeted shelves may require longer tacks or nails (not included).
Q: Will the MagMount support Glock magazines and other magazines that have a steel liner inside a polymer jacket?
A: Due to the polymer jacket, the MagMount will have only a tenuous hold on steel lined polymer magazines, so they tend to slide off the MagMount. But, if you orient the magazine with the floor plate up, place the side of the magazine against the MagMount instead of the back, and allow the lip of the floor plate to engage the top edge of the MagMount (see photo below), it will hold much better.
WARNING: For use with metal magazines only. Not for use with handguns, loaded magazines or knives. Keep out of reach of children.
|Capacity||Approximately 10 Magazines (depending in magazine size)|
|Capacity (Weight)||Max. 3 lb (Total)|
|Average rating from 1 reviews: 4.0|
Not Sticky EnoughHave had several of these for quite a while. Their grip on your steel mags is fine but their grip on your steel/metal safe needs a boost. They have a sticky back but mine continually slide slowly down the inside of my safe and have to be repositioned. May end up using Gorilla tape to hold them in place. Still handy to keep your mags aligned in one spot.
Submit a Review...