Custom Powder Funnel
Custom Powder Funnel
Click to enlarge image(s)
These Custom Powder Funnels are precision machined from top grade 12L14 Steel and hardened to RC55+ … offering an almost unlimited life time of use. The electro-polished finish of this part yields minimal friction and a smoother release … especially with new brass or brass that's been wet cleaned with stainless steel pins or in an ultrasonic cleaner.

Precision Machined from 12L14 Steel
Case Hardened to RC55+
Expander Tip Dimensions Optimized for use with Mr. Bullerfeeder
Highly Polished Expander Tip for Smooth Release
Smoother Interior for Smooth Powder Flow
Drop In Replacement for Original Dillon Powder Funnel *
Works on SDB, RL 550, XL 650, XL 750, RL 1050, Super 1050 and RL 1100 Presses
  * Powder Die adjustment will still be required.

Available Calibers
9mm/.38 cal. (T1582-01) — [Also works for .38 Super, .38 Special and .357 Magnum.]
10mm/.40 cal. (T1582-02)
.45 cal. (T1582-03) — [Also for .45 Colt with .452″ bullets.]

These Custom Powder Funnels work so well, you may want to use them on all your pistol cartridge toolheads … even toolheads that are not set up with a Mr. Bulletfeeder!

Manufactured by Photo Escape, Inc.
Custom Powder Funnel for .38 cal. shown in photo.
Made in USA Logo

Customer Reviews

Average rating from 18 reviews: 4.8 Showing: 3 of 18 Show All
WAY better than the original Dillon powder funnelIf you're loading cast bullets, this is far better than the Dillon powder funnel (powder through expander). If you're loading jacketed bullets, this is still an improvement over the Dillon funnel. The Uniquetek powder funnel is close to the profile of a Lyman "M" die type expander and is well suited for cast bullets. I have a few custom-made Dillon powder funnels but for 45 ACP I just use the Uniquetek powder funnel. I don't you could improve upon it.
If you're running a Dillon progressive press - this is an improvement that is well worth the cost.
Written by Jackbooted Thug on Sat 26 Mar 2022 5:54:28 PM GMT
Better expansion than factoryThe 45 powder funnel in my experience is better at expanding the case for bullet seating Without adding unnecessary belling to the case mouth. With the DIllon to expand as deep as I wish, the case gets a broad belling. While crimping addresses the bell, this is unnecessary addition of stress on the brass. I also noticed less sticking of the case on the funnel on the downward ram stroke. I am purchasing more, for 10mm and 38 Written by Andrew Z on Mon 22 Feb 2021 8:47:24 PM GMT
1.5m rounds and counting.We were using the originals when Mr. Bullet feature 1st came out And they would wear out about 10 to 15000 rounds in so this was a godsend we picked it up and we have not had a problem since it feeds all types of projectiles for 9 mil 40 and 45 works very well. I would say I would always replace these with the same but I haven't had to replace them yet. We use them on 1050s Automated for our manufacturing company. Written by Safer Bugout Industries on Fri 1 Jan 2021 4:24:14 PM GMT
Submit a Review...